'99 200 Unfinished track project

[RichMk3]

'99 V Plate 1.4 200. No TAX, no MOT. 56k miles 2 owners. Starts and drives.

As you can see, there is no interior. Needs Seat subframes and new straps for the petrol tank.

Body work is solid, but slight rust on rear arches starting to appear.

Comes with :-

Corbeau Buckets

Sparco harnesses

AVO Coilovers

Great condition 17's with barley legal rubber

Std 15" rims with legal rubber

Std Shocks and springs

New OMP Suede 3" dish 300mm Steering Wheel with snap off boss

WILL NEED COLLECTING ON A TRAILER.

Looking for £400ish or p/x with T16 bits, cash either way. Let me know what you have.

Don't be scared of making an offer, I realise that's the high end of what its worth, Im not easily offended - Ive been on here for 10 years after all

[RichMk3]

Bumpty bump!

£350 - want it out my way now...

[southside]

When you say needs trailering is that purely because of no tax/mot? Bearing in mind I'm on the same estate as you?

[RichMk3]

You could drive it round the estate mate, I have done, but the drivers side seat is only held in with mdf subframe as I used it as a template to make a metal one but never finished it. I wouldn't advise going any further LOL

Also the fueltank straps need replacing as I was going to run an alloy tank in the boot and there is less than 1L of petrol in it.

[RichMk3]

If nobody wants to make an offer on this, I'm going to break it over the next few weeks.

AVO Coilovers £180

17" Rims £80

Seats + Harnesses £80

Steering Wheel + Snap off boss £50

Low mileage 1.4k dizzy cap engine + R65 box £80

Ask for anything else you may need.

Ta.

[Cableguy]

Pics of the steering wheel please, and "dibs" pending that.

Are the harnesses 2 inch or 3 inch ? 4 point ?

What T16 bits are you after in terms of a part ex for entire car?

[RichMk3]

I'll get you some pics asap mate, the harnesses are 2" wide 3 points so pretty basic to be fair.

As regards px on T16 bits, I just want to fully rebuild a stock engine, or maybe forged pistons, to go in my zs.

[ghall2004]

If possible more images of the seats please

and if possible measurement of the width of them ie the area you would sit it

i am super fat you see

[pengy_666]

I've met Greg, he lies. He ain't super fat.

[ghall2004]

I've met Greg, he lies. He ain't super fat.

Lol thanks but i am a beast

[parker2245]

I'm interested, just bad timing as the clutch has just gone on my zs 180 have the heater controls been removed?

[matt077]

did you break this mate? if so still got the coilovers? can pick up too

[RichMk3]

I will do, I keep looking at it but I cant be arsed lol its too cold and wet atm.

Hopefully moving house soon too, so ill have a garage and I might keep it

[escortpop]

you have a pm mate.

[roleyyyy]

Hi their just wondered if you have sold the car or are breaking it many thanks kev.